1. Accurately remove the plastic decorative panel from the outer edge of a seat. At first the panel should be delayed forward, then to shift towards a door for the purpose of release from clamps.

2. Turn out the lower anchor bolt of fastening of a seat belt to a seat frame.

3. Shift a seat against the stop forward for the purpose of ensuring access to back fixing bolts. Turn out bolts.

4. Now shift a seat back and turn out forward bolts of its fastening.
5. On the models equipped with the electric drive of adjustment of provision of seats before dismantle it is necessary to make sure that the rechargeable battery is switched-off.
6. At the corresponding complete set disunite the contact socket(s) of the electrical wiring laid under a seat.
7. Remove a seat and take it from interior of the car.
8. Remove plastic floor boards (try to remember their adjusting situation).

1. Lift a first line of a pillow and incline it forward.
2. Remove decorative covers from seat loops.
3. Give nuts of fastening of a pillow to loopy assemblies, then take a pillow from interior of the car.

1. Release a clamp and put a back forward.
2. Turn out screws of fastening of a back to the loopy assemblies located in the opposite ends of a seat. Lift a back and take it from interior of the car.

1. Perform procedures of the subsection "Pillow of a Back Seat (Seat of a Continuous Design) — Removal". For the purpose of ensuring access to nuts of fastening of loopy assemblies it is necessary to remove decorative covers from them.

1. Release a clamp and put a seatback forward.
2. Turn out fastening screws to a floor of the loopy assemblies located on both sides of a seatback. Pay attention that at removal of a back of a smaller seat it is enough to turn out fastening screws to a floor only of an external loop.
3. Lift a back and take it from interior of the car. At removal of a back of a smaller seat its inner edge should be released from a loopy level.