1. Open a door and approximately on two thirds lower a windowpane. Disconnect a negative wire from the battery.

2. Extend the button of switching off of the lock, then by means of the small screw-driver wring out a lock uvula and finally remove the button.

3. On models with the manual drive of window regulators remove the handle of management from the spindle, then remove a facing plate.

4. Turn out the screw located in the lower back end of facing of the internal handle of a door.

5. Having accurately hooked, remove the facing panel from the handle. At the corresponding complete set, delay the panel of an internal upholstery from a doorframe and disunite contact sockets of an electrical wiring of the drive of a window regulator / a door rear-view mirror. If door mirrors are equipped with the manual drive, remove decorative finishing of the driving mechanism from the panel of an internal upholstery.

6. Turn out two lower screws of fastening of an armrest.

7. Through an opening in the door handle turn out the top screw of fastening of an armrest (pay attention that the internal handle is a part of a design of an armrest).

8. Turn out the screw of fastening of the panel of an internal upholstery, located from the forward party of an opening of the internal handle.

9. Having accurately hooked the screw-driver, remove the loudspeaker cover panel.

10. Turn out three screws of fastening of the panel of an internal upholstery located around the loudspeaker loudspeaker.

11. Hooking the suitable bifurcate tool, release the clamps located on perimeter of a door and remove the panel of an internal upholstery (do not forget to disconnect an electrical wiring from a loudspeaker).

12. If there is a need for removal of the plastic sealing screen, it is necessary to dismantle previously the internal handle (see Removal and installation of door handles and components of the lock) and, at the corresponding complete set, the control unit of the window regulator electric drive:
   a) The control unit of the electric drive of a window regulator fastens two screws used also for fixing of a block of contact sockets of an electrical wiring. Disconnect an electrical wiring, then turn out screws and remove the block;
   b) Release contact sockets from a block and remove the last;
   c) On the models equipped with the anticreeping alarm system disunite the contact socket of an electrical wiring of the sensor of tracking (the sensor is built in in the decorative panel of finishing of a door mirror).

13. Accurately separate the sealing screen from a doorframe (if the screen is not replaced, try not to damage a film). At removal of the screen pass electrical wiring plaits through openings through passage in it.

1. Installation is made upside-down. Pay attention to the next moments:
   a) Replace the fixing clamps damaged in the course of dismantle of the panel of an internal upholstery;

   b) Make sure that the coupling screw of an executive rod of the door lock after installation of the internal handle was tightened;

   c) At installation of the button of switching off of the lock at first close a door and make sure that the executive rod of the switch is in the lower situation. Translate a lock uvula in lower of two openings, then densely put the button for the end of a rod (before click), - the lock uvula at the same time has to appear in the top opening.

1. Disconnect a negative wire from the battery.
2. Open a door.
3. Perform the procedures described in the subsection "Forward Doors — Removal", subitem 2 — 11.
4. In need of removal of the plastic sealing screen at first release fastening clamps on a door of a basic arm of an electrical wiring.