1. Disconnect a negative wire from the battery.
2. Remove the central console (see Removal and installation of the central console).

3. Release the block from a basic arm and disconnect from it an electrical wiring.

1. Disconnect a negative wire from the battery.
2. Open a back door.
3. Open hatches of access and disconnect an electrical wiring from the combined lamps which are built in a door back.
4. Release clamps, turn out fixing screws and remove the panel of the lower finishing of a door of a back.

5. Turn out two fixing bolts.

6. Take the activator of the door lock, then disconnect from it an electrical wiring.

7. Installation is made upside-down.

1. Having accurately hooked, remove the panel of a cover of an electric motor of the drive of the top hatch.

2. Release clamps and remove the receiver of signals of the DU panel of the uniform lock from the cover panel, disconnect an electrical wiring.

3. Installation is made upside-down.

1. Turn out the small self-cut screw in a back part of assembly of the transmitter. Extend the transmitter from a back cover for the purpose of ensuring access to batteries.
2. Take batteries (try to remember their correct adjusting situation).
3. Install by the correct image two new batteries, establish into place a cover and tighten the self-tapping screw.