1. Disconnect a negative wire from the battery.
2. Open a back door.
3. Open hatches of access and disconnect an electrical wiring from the combined lamps which are built in at a door back.
4. Release clamps and turn out fixing screws and remove the lower panel of an internal upholstery of a door of a back.
5. Release clamps of fastening of an emphasis of the back shelf on panels of a side upholstery of a door of a back (beat out the central pins, then take clamps). Remove an emphasis.

6. Turn out fixing screws and remove side panels from a back door.

7. Disconnect an electrical wiring from the consumers of the electric power located in a door (including contact sockets on both sides of a heater of back glass). If the door is not replaced, tie up string pieces to electrical wiring plaits.
8. Accurately disconnect a hose of supply of liquid of washing of back glass from a nozzle on assembly of an electric motor of a screen wiper. Prepare for collecting the spilled liquid. Release a hose from a door at the top together with an electrical wiring plait.
9. Take rubber plugs of an electrical wiring through passage from the top end face of a door, then release plaits of wires from a door. Leave the tied-up string pieces sticking out of openings through passage.
10. Ask the assistant to take a door and serially release spring clamps of both telescopic emphasis. Release spherical hinges of an emphasis from reception nests on doors.

11. Screw fixing bolts and by means of the assistant remove a back door from the car. Transfer a door to the safe place.

1. By means of the assistant get a door on the regular place, screw and tighten fixing bolts.

2. Further installation is made as it should be, the return to a dismantle order. Pay attention to the next moments:
   a) Gas station at a door of plaits of an electrical wiring is made by means of left passed through openings of pieces through passage of a string;

   b) After installation of a door check uniformity of its arrangement of rather adjacent body panels. In case of need release adjusting bolts and make the corresponding adjustment. Having achieved satisfactory result, do not forget to tighten adjusting screws;

   c) Having adjusted the provision of a door, check serviceability of functioning of its locks. In case of need weaken fixing bolts (it is necessary to remove the back panel of finishing of a door - see Removal and installation of components of the lock of a door of a back) and as appropriate correct position of locks.

1. Prop up a back door in open situation.

2. By means of the screw-driver with a flat sting release a spring clamp of a spherical support of a telescopic emphasis on doors.

3. Take a clamp from a support.

4. Repeat the procedure, having released the hinge since the opposite end of an emphasis. Remove an emphasis from the car.