1. Disconnect a negative wire from the battery.
2. Open a back door
3. Open hatches of access and disconnect an electrical wiring from assemblies of the back combined lamps which are built in at a door.

4. Remove clamps.
Above — Extraction of the central pin of a clamp
Below — Extraction of a clamp of fastening of the finishing panel of a door of a back

5. Turn out fixing screws.

6. Remove the lower panel of finishing of a door of a back.

7. Mark the provision of heads of bolts of fastening of castle assembly.

8. Turn out two fixing bolts and remove assembly of the lock, having disconnected from it an executive rod.

1. Perform the procedures described in the subsection "Assembly of the Lock — Removal", subitem 1 — 4.
2. At the corresponding complete set screw two fixing bolts and remove the block of the activator of the uniform lock. Having removed the servo-driver, disconnect an executive rod and an electrical wiring from the lock.

3. Turn out three fixing screws, take sideways the lock cylinder from a door and disconnect the remained executive rod.

4. For extraction of the cylinder from assembly remove a foam sealing ring, then insert a key into a keyhole and at the same time release a lock uvula of fastening of the cylinder. For a key take the cylinder.

1. Uncover and turn out screws of fastening of the back panel of an upholstery of the luggage compartment. Remove the panel, having provided thereby access to the lock drummer.

2. Unbend edge of a carpet back and turn out two bolts of fastening of the drummer. At the corresponding complete set release the sensor switch of the anticreeping alarm system from assembly of the drummer.