1. Remove the panel of an internal upholstery of a door (see Removal and installation of panels of an internal upholstery of doors).
2. Separate and unbend the top forward corner of the plastic sealing screen of a door for the purpose of ensuring access to the plug of a driving cable through passage of the regulator of provision of a mirror. Take the plug from the door panel.
3. Having hooked, release the panel of decorative finishing from a door corner, at the corresponding complete set release from clamps on the panel the sensor of tracking of the anticreeping alarm system, then remove the panel.
4. Turn out five fixing screws and remove assembly of a rear-view mirror from a door. Pass a driving cable through an opening throughout doors. Try to remember a route of laying of a cable.

1. Remove the panel of an internal upholstery of a door (see Removal and installation of panels of an internal upholstery of doors).

2. Find the ends of a spring clamp of fastening of the glass located from the upper edge of assembly of a mirror. Where it is required, remove the control unit of the window regulator electric drive with a block of the contact socket for the purpose of ensuring access.

3. Take the rubber plug of an electrical wiring through passage from the door panel.

4. Having hooked, release the panel of decorative finishing of knot of fastening of a mirror from a door corner. At the corresponding complete set release the sensor of tracking of the anticreeping alarm system from the panel, then remove the panel.

5. Walk on an electrical wiring plait from a mirror to a block and disunite contact sockets. At the corresponding complete set disconnect also an electrical wiring of the temperature sensor.

6. Turn out five fixing screws and remove assembly of a mirror from a door. Release an electrical wiring plait from a door.

1. Glass fastens in assembly of a mirror by means of a metal spring clamp.
2. Find the ends of a clamp of fastening of the glass located from the upper edge of assembly of a mirror. Where it is required, remove the control unit of the window regulator electric drive with a block of the contact socket for the purpose of ensuring access.

3. Hook the ends of a clamp the screw-driver for the purpose of mirror glass release.

4. Remove glass, at the corresponding complete set disconnect an electrical wiring. Remove a spring clamp if it is put freely from assembly.
A — Contact sockets of an electrical wiring
B — the Spring clamp

1. Establish a spring clamp on the back party of glass of a mirror. Track that the ends of a clamp correctly entered glass grooves.
2. Fill glass in assembly of a mirror to a clamp zashchelkivaniye in an adjusting flute.

For simplification of landing of a clamp previously slightly grease a plastic ring on the regulator.