1. Dump pressure in hydraulic system (see the Head Uniform hydraulic system).
2. The car also establish to Poddomkratta it on props. Remove forward wheels.
3. Under the car remove a protective cover from a nut of the cranked lever of the drive of gear shifting, give a nut and disconnect draft of switching from the rotary support on a stretcher.

4. Turn out fastening boats to a stretcher of the mechanism of rack steering transfer, remove remote plugs. A wire tie up assembly of the steering mechanism to system of production of the fulfilled gases.

5. Give a nut and take a bolt of fastening of an arm of a back support of the power unit to the rubber pillow.

6. On both sides of the car turn out bolts of fastening of loker of wheel arches to a stretcher.
7. Serially weaken and partially turn off nuts of fingers of both lower spherical support, then divide support by means of the special tool. After release of spherical fingers finally remove nuts from their shafts.
8. Working in the same manner, by means of a divider of spherical support serially disconnect racks of the stabilizer of cross stability from the ends of its bar. At an otdavaniye of nuts the finger of a rack can be held from a provorachivaniye by means of a prutkovy key on 5.0 mm.
9. From the left board of the car weaken and partially turn off a nut of a spherical finger of fastening of a tip of steering thirst for stupichny assembly. Release a finger from the landing nest by means of a divider of spherical support, then finally remove a nut.

10. In the right back corner of a stretcher turn out two bolts and release a clamp of fastening of a guide of lines of communication (wires and hydraulic tubes). For an otpuskaniye of a clamp beat out its central pin.

11. On the models equipped with a hydroactive suspension bracket disconnect an electrical wiring from the sensor of movements of a body.

12. Turn out two bolts of fastening of valvate assembly of the proofreader of a road gleam to a stretcher.

13. Weaken a coupling bolt and disconnect an executive rod of manual correction of a road gleam from the proofreader.

14. Disconnect hydraulic tubes from the proofreader's valve. At once to a zakuporta the open ends of lines and reception ports of the valve in order to avoid hit in system of dirt.

15. Turn out three bolts of fastening of basic arms of lines of communication in the left back corner of a stretcher.

16. Take a fastening clamp on a stretcher of a guide of lines of communication. For an otpuskaniye of a clamp beat out its central pin.

17. Disconnect tips of cables of the drive of the parking brake from executive levers of supports of brake mechanisms. Release covers of cables from the bearing ledges on supports. Take assemblies of cables aside.
18. Since both ends of a stretcher release hydraulic tubes from basic arms (separate flexible hoses from tubes, then release tubes from intermediate clamps on a stretcher) (address the Head the Brake system).
19. Turn a steering wheel against the stop to the left.
20. Attentively examine a stretcher and release from clamps on it all remained lines of communication (wires, hydraulic tubes and hoses (perhaps, it is necessary to make a detachment of some lines). Try to remember routes of laying of all wires, hoses and tubes. At a rassoyedineniye of nipple sockets be ready to collecting the spilled liquid. At once cork the open ends of tubes/hoses and unions of their connection for the purpose of minimization of losses of hydraulic liquid and in order to avoid hit in system of dirt.
21. Prop up a stretcher a cart jack through wooden whetstone.

22. Turn out six fixing bolts and slightly lower a stretcher on a jack.

23. Last time make sure that no communication tenches prevent removal of a stretcher.
24. Finally lower a stretcher and take it from under the car.
25. At desire the lower levers and a bar of the stabilizer of cross stability can be removed from a stretcher (see appropriate sections).