6f6d7d92


13.7. Removal and installation of the proofreader of height of a road gleam of a forward suspension bracket

Removal

At the corresponding complete set new sealing couplings of nipple sockets of hydraulic tubes will be required.


 PERFORMANCE ORDER

1. Dump pressure in hydraulic system (see the Head Uniform hydraulic system).
2. The car also establish to Poddomkratta it on props
3. Mark the adjusting provision of hydraulic tubes, then disconnect them from assembly of the proofreader of a road gleam. Get suitable drain capacity under assembly of the proofreader and disconnect hydraulic tubes. At once to a zakuporta the open ends of tubes and unions of their connection for the purpose of minimization of losses of liquid and in order to avoid hit in system of dirt.

4. Turn out bolts of fastening of the proofreader and release driving rods from the executive lever of assembly, remembering adjusting provisions of components. Take assembly of the proofreader from under the car.
1 — two hydraulic tubes
2 — fastening bolts

Installation

Recovery repair of the proofreader of height of a road gleam is not possible. In case of a device exit out of operation make replacement it assembled.

Installation is made upside-down. Pay attention to the next moments:
   a) Track correctness of connection and reliability of fastening of hydraulic tubes, at the corresponding complete set do not forget to replace sealing couplings of nipple sockets;
   b) Do not forget to grease spherical hinges of driving rods before connection them to the executive lever of the proofreader;
   c) After lowering of the car on the earth tighten spuskny the gate of the regulator of pressure and transfer a control lever a suspension bracket to situation "Maximum";
   d) Check the level of hydraulic liquid, in case of need make the corresponding adjustment (address the Head Routine maintenance);
   e) In conclusion check installation of a road gleam (see Check of installation and adjustment of a road gleam).