1. Prop up back wheels of the car, then a front of the car and establish to a poddomkratta it on props. Remove the corresponding forward wheel.
2. Weaken and partially turn off a nut of a spherical finger of fastening of a tip of steering draft on stupichny assembly, then release a finger from a reception nest by means of a divider of spherical support. Remove a nut.
3. If the tip is used further, mark its situation to a draft bar.
4. Record a draft bar from a provorachivaniye and give half way a lock-nut.
5. Having precisely counted quantity of turnovers of a carving, turn out and remove its tip from draft.
6. Count and write down quantity of naked rounds of a carving from an end face of the spherical hinge of a tip to a lock-nut. Check serviceability of a condition of a tip, its protective cover, shaft and carving of a spherical finger. In case of identification of the hinge of a side play or mechanical damages indicating wear make replacement.
7. Carefully clean a carving on a draft bar.

1. At installation of a new tip transfer to it an old lock-nut, having screwed it so that that the quantity of naked rounds of a carving corresponded to the value recorded in the course of dismantle.
2. Screw a tip in draft on the quantity of turns counted in the course of dismantle. At the same time the lock-nut of a tip has to be remote from an emphasis on a quarter of a turn (be verified with the marking put earlier).
3. Fix a tip in stupichny assembly and screw a new nut of a spherical finger, having tightened it with the required effort.
4. Establish a wheel, then lower the car on the earth and tighten wheel bolts with the required effort.
5. Check the angles of installation of forward wheels (see the Angles of installation of wheels - the general information, check and adjustment of convergence of forward wheels), then strongly tighten a lock-nut of a tip of steering draft.