1. In motive, manipulating the operating TNVD lever, disconnect from it the gas cable core.

2. Release a cable cover from the plug through passage in a pump arm.

3. Release a cable from the remained intermediate clamps and arms in a motive compartment. Try to remember a route of its laying precisely.
4. In interior of the car release clamps and remove the lower felt section of finishing of the dashboard in a driver's foot well.
5. Having turned on a quarter of a turn counterclockwise, release a clamp and uncover the assembly block of safety locks. Having released the remained clamps, remove the lower felt cover established under the dashboard from the driver's party of the car.
6. Release a clamp and disconnect the cable core from the accelerator pedal.
7. Release a cable cover from an arm on the accelerator pedal.
8. Accurately push a cable through the plug through passage from a motive compartment in salon and remove it from the car.

1. Remove a spring clamp from a gas cable cover. Make sure that the operating TNVD lever is pressed to an emphasis, then carefully pull a cable from the plug through passage, completely choosing a weak point of its core.
2. Having recorded a cable this situation, establish a spring clamp in the last from visible flutes in front of the rubber plug through passage and a washer. After a cover otpuskaniye the core of a cable has to receive the minimum weak point.
3. Ask the assistant to squeeze out the accelerator pedal and make sure of completeness of movement of the operating TNVD lever. At a pedal otpuskaniye the lever has to come back to a starting position, nestling on an emphasis.