1. Remove the forward index of turn from the corresponding board of the car (see below) and a forward lattice (address the Head Kuzov and finishing of salon).
2. Turn out two top fixing screws and one lower.

3. Remove assembly of a block headlight from the car (the top bolts are shown by shooters).

4. Disconnect the electrical wiring brought to assembly.

5. In case of need the lens can be removed from a headlight:
   a) Accurately hooking the screw-driver, release clamps of fastening of edges of a lens. At assembly clamps are subject to replacement without fail;

   b) Carefully remove a lens from a block headlight. Try not to touch with fingers a reflector mirror surface;
   c) Remove and will throw out sealing laying;
   d) Clean an adjusting flute in a casing of a block headlight and put in it new sealing laying;

   e) Put on ledges at the edges of a lens new fixing clamps, then press a lens to a casing of assembly of a block headlight and in strictly certain order latch clamps.

1. Open a cowl.

2. From the inside of a wing release a fixing clamp and push out outside assembly of the index of turn (the arrow showed a fixing clamp).

3. Disconnect an electrical wiring and remove assembly of the index from the car.

1. Shift assembly of the repeater forward and release it from the body panel of the car.
2. Disconnect an electrical wiring and remove assembly of the repeater.

1. Pull facing of assembly of a fog light before the click confirming an otpuskaniye of clamps forward.

2. Push the screw-driver in the top corner of an air vent in a spoiler and wring out a clamp of fastening of assembly of a fog light.

3. Having pulled on itself, release assembly of a fog light from the landing nest (the arrow showed a fixing clamp).

4. Disconnect it from a spoiler (the arrow showed a lock uvula).

5. Disconnect an electrical wiring and remove assembly of a fog light from the car.

1. Installation is made upside-down. Before filling assembly in a spoiler, make sure that its facing is shifted in the forward (released) situation. First of all fill the lock uvula located from the outer edge of a headlight in a spoiler.
2. Having put assembly aflush with a spoiler surface, fix it by a clamp.

1. Open a back door.
2. Release a clamp and remove a folding cover from the back party of lantern assembly.
3. Disconnect an electrical wiring from a back part of a lamp holder, then release two fixing clamps and remove a lamp holder.

4. Having hooked the screw-driver, release an internal clamp.

5. Then pull lantern assembly outside and release two remained external clamps.

1. In the luggage compartment of the car give a fixing nut and remove assembly of the back combined lamp from a wing.

1. Having accurately hooked the screw-driver, release assembly of a lamp of illumination of registration plate from the back door panel.
2. Disconnect an electrical wiring and remove assembly of a lamp from the car.