1. Disconnect a negative wire from the battery.
2. Before a detachment of the battery make sure that the brush of a screen wiper holds parking position.
3. Remove the screen wiper lever (see Removal and installation of the lever of a screen wiper).

4. Turn out fixing screws / release the clamps located on both sides of a protective cover of the drive of a screen wiper.

5. Accurately cut with a fine edge the sealant located between the panel of a cover of the drive and a surface of a windshield.

6. At the corresponding complete set uncover the isolating sensor switch of the anticreeping alarm system with a sealing ring.

7. Take the sensor switch from a cover of the drive of screen wipers. Remove the cover panel.

8. Turn out six fixing bolts and release assembly of an electric motor with driving drafts.

9. Disconnect an electrical wiring and remove driving assembly from the car.