6f6d7d92


15:14. Removal and installation of a driving cable of the speedometer/sensor of speed

Some of models are equipped with a speedometer of electronic type with the speed sensor installed on the transmission which replaces with itself(himself) the hummock drive used in system of mechanical type.

Hummock drive

Removal

 PERFORMANCE ORDER

1. In a motive compartment take a pin of fastening of a driving cable on a transmission case. Disconnect a cable tip from transmission.
2. Sharply extend a driving cable for the purpose of release of its spherical tip from the directing plug in a partition of a motive compartment.
3. Involve a cable in a motive compartment and remove it from the car. Try to remember a route of laying of a cable and location of its intermediate guides of clamps.

Installation

Installation is made upside-down. Before landing grease a sharovy tip of a cable with soap solution. Track correctness of laying of a cable and its landing in the plug through passage in a partition.

Speed sensor

Removal

 PERFORMANCE ORDER

1. It is the simplest to approach the sensor from under the car. For the purpose of simplification of access prop up antiretractable boots back wheels, then a front of the car and establish to a poddomkratta it on props.
2. Disunite the contact socket of an electrical wiring of the sensor of speed.
3. Turn out a fixing bolt and remove the sensor together with the thermofilter.

Installation

Installation is made upside-down. Make sure of serviceability of a condition of a sealing ring in the sensor basis, in case of need make its replacement. At the corresponding complete set do not forget to install into place the sensor thermofilter.