12.7. Removal, capital repairs and installation of supports of disk brake mechanisms of back wheels
|
|
See the preventions provided in the section the Brake system. At assembly new sealing washers of the nipple socket of a hydraulic tube will be required. |
Details of fixture of a support of the back brake mechanism
Pay attention that before removal the support has to be fastened by a finger of fastening of blocks
|
|
1 — the Hydraulic tube
2 — Bolts of fastening of a support
3 — the Finger of fastening of blocks
3 — the Nut of a fixing finger |
Components of the brake mechanism of a back wheel
|
|
1 — the Brake board and the filter of blocks
2 — the Piston with cuffs
3 — the Finger of fastening of brake shoes
4 — Antivizgovaya a spring
5 — the Brake shoe (internal)
6 — the Support of the brake mechanism
7 — the Brake disk |
Removal
|
|
|
1. The car also establish to Poddomkratta it on props.
2. Remove the corresponding wheel.
3. Dump pressure in hydraulic system for what weaken spuskny the regulator gate (see the Head Uniform hydraulic system) and transfer a control lever a suspension bracket to situation "Minimum".
4. Remove brake shoes (see Replacement of blocks of disk brake mechanisms of back wheels).
5. Fasten among themselves two half of a support, having established into place a bolt of fastening of blocks and having strongly tightened its nut.
6. Get drain capacity under the connection union to a support of a hydraulic tube. Release the nipple socket and disconnect a tube from a support. At once to a zakuporta the open ends of a tube and the union for the purpose of minimization of losses of hydraulic liquid and in order to avoid hit in system of dirt.
7. Turn out two fixing bolts and remove assembly of a support (see an illustration
of the Detail of fixture of a support of the back brake mechanism). |
|
Capital repairs
Performance of recovery repair of the failed support is possible only with application of a company remnabor of the Citroyon company. Track that the remnabor corresponded to type of the support removed from the car. Pay attention to correctness of installation of each of components. And a sealant before installation grease new laying with hydraulic liquid. For the rest follow instructions of manufacturers. The design of the brake mechanism is presented on an illustration
Components of the brake mechanism of a back wheel.
Installation
|
|
|
1. Grease a carving of fixing bolts, then establish a support on the regular place, screw bolts and tighten them with the required effort.
2. Connect a hydraulic tube to a support (do not forget to replace sealing washers). Strongly tighten the nipple socket.
3. Give a nut and take a finger of fastening of blocks from a support.
4. Establish into place brake shoes (see Replacement of blocks of disk brake mechanisms of back wheels).
5. Establish a wheel.
6. Tighten spuskny pressure regulator gate (see the Head Uniform hydraulic system) and transfer a control lever a suspension bracket to situation "Normal driving" (The normal movement).
7. Lower the car on the earth and tighten wheel bolts with the required effort. |
|
