6.1.8. Removal and installation of the sensor of fuel consumption
The sensor of fuel consumption is built in assembly of the fuel pump (see Removal and installation of the fuel pump).
- 1. Introduction
- 2. Operation manual
- 3. Routine maintenance
- 4. Repair of the engine
- 5. Cooling systems, heating
- 6. Power supply system and release
- 6.1. A power supply system - petrol models
- 6.1.1. Removal and installation of assembly of the air cleaner
- 6.1.2. Removal, installation and adjustment of a cable of gas
- 6.1.3. Removal and installation of the accelerator pedal
- 6.1.4. Unleaded fuel - the general information and rules of use
- 6.1.5. Systems of injection of fuel - the general information
- 6.1.6. Dropping pressure in a power supply system
- 6.1.7. Removal and installation of the fuel pump
- 6.1.8. Removal and installation of the sensor of fuel consumption
- 6.1.9. Removal and installation of the fuel tank
- 6.1.10. Check of a state and adjustment of system of injection of fuel
- 6.1.11. Removal and installation of the case of a throttle
- 6.1.12. Removal and installation of components of the Bosch Motronic 5.1 system
- 6.1.13. Removal and installation of components of the Magneti-Marelli 8P system
- 6.1.14. Removal and installation of the inlet pipeline
- 6.1.15. Removal and installation of a final collector
- 6.2. A power supply system - diesel models
- 6.3. Systems of decrease in toxicity and production of the fulfilled gases
- 6.1. A power supply system - petrol models
- 7. Engine electric equipment
- 8. Coupling
- 9. Transmission
- 10. Power shafts
- 11. Uniform hydraulic system
- 12. Brake system
- 13. Running gear and steering
- 14. Body and finishing of salon
- 15. Onboard electric equipment
- 16. Schemes of electric equipment
