1. Take off a belt of the drive of auxiliary units (address the Head Routine maintenance).

2. For fixing of a bent shaft during an otdavaniye of a bolt of fastening of a pulley include the 4th transfer and ask the assistant to squeeze out a foot brake firmly. If the engine is removed from the car, block a gear wreath of a flywheel by means of special adaptation.

Do not try to record a shaft by threading of a core in a blocking opening of a pulley at all (see Fixing cranked/distributive in bulk for the purpose of prevention of service of the car, casual in the course of performing procedures)! If the core is already inserted, temporarily take it.

3. Turn out a fixing bolt, throw off a washer and remove a pulley from a pin of a bent shaft. If the pin, or a segment spline (depending on a complete set) is put freely, take him / her and remove to the reliable place. If the pulley is put on a shaft pin too densely, use a suitable stripper.

1. Make sure available on the place and reliability of landing of a segment spline / a landing pin, then put on a pulley a pin of a bent shaft.
2. Carefully smooth out a carving part of a fixing bolt, then grease it with the fixing sealant like Loctite.
3. Screw a bolt (do not forget about a washer) and tighten it with the required effort, holding a bent shaft from a provorachivaniye in the same way to which resorted at an otdavaniye.
4. Establish into place a belt of the drive of auxiliary units (address the Head Routine maintenance).