1. Remove a cogwheel of a bent shaft and (at the corresponding complete set) the remote plug (see Removal, check of a state and installation of a natyazhitel and cogwheels of a gas-distributing belt). Take a gas-distributing belt aside from a working zone and fix it in order to avoid pollution by oil there. Measure and write down the adjusting depth of landing of an epiploon in the casing.

2. Puncture, or drill couple of small openings in a face surface of an epiploon and screw in them self-tapping screws. Grasp heads of screws with nippers and take an epiploon from the nest in a casing. Alternatively the epiploon can be taken by a poddevaniye by the screw-driver with a flat sting - try not to damage walls of a nest and persistent coat hanger on a shaft pin.

3. Clear a casing of an epiploon and carefully remove from walls of a nest and a pin of a shaft all roughnesses and teases capable to lead to failure of a new epiploon.
4. Oil sponges of a new epiploon pure motive, then accurately put on it a pin of a bent shaft (sponges inside). Try not to damage soft sponges of an epiploon at putting on it on a pin.
5. By means of a suitable mandrel (a face head of the corresponding size or a piece of a pipe of the corresponding diameter) begin to knock an epiploon in a casing nest on former depth (see item 1).
6. Collect by rags excess of oil and establish into place a cogwheel of a bent shaft (see Removal, check of a state and installation of a natyazhitel and cogwheels of a gas-distributing belt).

1. Remove a flywheel / a driving disk (see Removal, check of a state and installation of a flywheel / a driving disk). Measure and write down the adjusting depth of landing of an epiploon in the casing.
2. Puncture, or drill couple of small openings in a face surface of an epiploon and screw in them self-tapping screws. Grasp heads of screws with nippers and take an epiploon from the nest in a casing.
3. Clear a casing of an epiploon and carefully remove from walls of a nest and a pin of a shaft all roughnesses and teases capable to lead to failure of a new epiploon.
4. Oil sponges of a new epiploon pure motive, then accurately put on it a pin of a bent shaft (sponges inside). Try not to damage soft sponges of an epiploon at putting on it on a pin.
5. By means of a suitable mandrel (a face head of the corresponding size or a piece of a pipe of the corresponding diameter) begin to knock an epiploon in a casing nest on former depth (see item 1).
6. Collect by rags excess of oil and establish into place a flywheel / a driving disk (see Removal, check of a state and installation of a flywheel / a driving disk).