1. Prop up antiretractable boots back wheels, then a front of the car and establish to a poddomkratta it on props. Transfer the selector lever to situation N.
2. Remove the thermofilter(s) of system of production of the fulfilled gases for the purpose of ensuring access to the basis of assembly of the lever of the selector (see the Head of the Power supply system and release).
3. Perform the procedures described in the subsection "Removal", subitem 6 — 8, the section Removal and installation of a driving cable of the choice of transfers of AT.
4. Under the car disconnect lever assembly from the bottom of the car and omit it down.
5. Having hooked, remove from the basis of the lever and shift a rubber protective cover along a driving cable.
6. Weaken a nut of fastening of a cover of a cable and release a fixing clamp. Accurately separate a cable tip from the spherical hinge in the lever basis, then take assembly of the last from under the car.

1. Perform the procedures described in in the subsection "Installation", subitem 1 — 6, the section Removal and installation of a driving cable of the choice of transfers of AT.
2. Install into place the thermofilter(s) of system of production of the fulfilled gases (see the Head of the Power supply system and release), then lower the car on the earth.
3. In conclusion check correctness of adjustment of a cable of the drive of gear shifting, in case of need make the corresponding adjustment (see Adjustment of a driving cable of the choice of transfers of AT).