1. Prop up antiretractable boots back wheels, a front of the car and establish to a poddomkratta it on props. Remove the right forward wheel.

2. In an arch of a wheel remove a plastic cover from a cornice, having provided thereby access to the right wall of the power unit.

3. Turning the engine for a bolt of a pulley of a bent shaft by means of a face key with the suitable drive, attentively examine an auxiliary driving belt on all its length. Pay attention to defects like cracks, stratifications and attritions. Inadmissibly also existence of sites, zapolirovanny to gloss. The defective or worn-out belt is subject to replacement.
4. If the condition of a belt is found by satisfactory, make adjustment of effort of its tension (except equipped To/in models where the automatic natyazhitel is provided).

1. If did not do it yet, perform procedures 2 — 3, described in "Check".
2. Disconnect a negative wire from the battery.

3. Weaken fixing and adjusting bolts of an arm of a tension roller (one of bolts is located in the central part of a roller, the second symbol - below on an arm).

4. Against the stop tighten an adjusting bolt and take off a belt from pulleys.

5. Check freedom of rotation of a tension roller.

1. If did not do it yet, perform procedures 2 — 3, described in "Check".
2. Respect for correctness of adjustment of effort of a tension of a driving belt is the key to duration of term of its service. Too poorly tense belt usually begins to whistle. You remember also that excessively strong tension of a belt leads to overloads and premature wear of bearings of the generator.
3. The belt has to be tense so that at a firm nazhimaniye on it a thumb on the site in the middle between the pulleys which are most removed from each other the size of a deflection made about 5 mm (see the remark at the beginning of the section).
4. Correction of a tension of a belt is made by rotation of an adjusting bolt. Having achieved satisfactory result, several times turn a bent shaft, then repeat check. Strongly tighten fixing/adjusting bolts.
5. Connect a negative wire to the battery.
6. Establish into place a plastic cover of a cornice of a wing and the right forward wheel, then lower the car on the earth and tighten wheel bolts.

1. If did not do it yet, perform the Checks procedures.
2. Disconnect a negative wire from the battery.
3. Pass a prutkovy key of square section throughout a special opening in the lower part of an arm of a natyazhitel and begin to rotate a natyazhitel counterclockwise, weakening thereby a belt. For fixing of a natyazhitel in the released situation pass a prutkovy key on 4 mm throughout a special opening and tighten a pin.
4. Turn out fixing bolts and shoot a video of a natyazhitel, then throw off a belt from pulleys.
5. Check freedom of rotation of a roller of a natyazhitel.

1. Make sure that the replaceable belt corresponds failed on the standard size. Throw with a new belt pulleys, having tracked correctness of hit of edges in streams.
2. Establish a roller of a natyazhitel and tighten fixing bolts.
3. By means of a prutkovy key of square section record a natyazhitel, a usual prutkovy key (on 4 mm) release a pin and slowly release assembly, having allowed it to make a belt tension. Still make sure of correctness of hit of edges of a belt in streams of pulleys.
4. Connect a negative wire to the battery.
5. Establish into place a plastic cover of a cornice of a wing and the right forward wheel, then lower the car on the earth and tighten wheel bolts with the required effort.